Ball Bearing, Pressed Steel Housing, Self-Aligning, Heavy Gauge Type PBPH-BL - Series
Pillow Block Bearings
View Catalog Page
- Heavy gauge pressed steel two-piece housing is crimped together at the bolt holes & has a rust-proof plated finish
- Bearing inserts are encased in an extra thick, non-conductive oil resistant rubber liner which corrects up to a 2° misalignment while reducing vibration & noise
- Ball bearing is pre-lubricated & made to ABEC-1 tolerances
- Wide inner race locks securely to the shaft with two set screws
- Neoprene seal keeps contaminants out allowing for usage in wet or dry conditions
- Operating Temperature Range: -30° F to 200° F
View Catalog Page
Item # |
Bore Size |
A |
B |
C |
D |
E |
F |
G |
CAD |
|---|---|---|---|---|---|---|---|---|---|
| PBPH-BL-050 | Bore Size N/A 1/2 in | A N/A 1 5/16 in | B N/A 2 5/8 in | C N/A 4 7/16 in | D N/A 3 7/16 in | E N/A 7/16 in | F N/A 9/64 in | G N/A 1 11/16 in |
CAD
N/A 
|
| PBPH-BL-062 | Bore Size N/A 5/8 in | A N/A 1 5/16 in | B N/A 2 5/8 in | C N/A 4 7/16 in | D N/A 3 7/16 in | E N/A 7/16 in | F N/A 9/64 in | G N/A 1 11/16 in |
CAD
N/A
|
| PBPH-BL-075 | Bore Size N/A 3/4 in | A N/A 1 5/16 in | B N/A 2 5/8 in | C N/A 4 7/16 in | D N/A 3 7/16 in | E N/A 7/16 in | F N/A 9/64 in | G N/A 1 11/16 in |
CAD
N/A
|
| PBPH-BL-100 | Bore Size N/A 1 in | A N/A 1 1/2 in | B N/A 2 7/8 in | C N/A 5 3/16 in | D N/A 4 in | E N/A 1/2 in | F N/A 9/64 in | G N/A 1 7/8 in |
CAD
N/A
|
