Pillow Block Bearings are available with housing units made from die-cast zinc, pressed steel and pressed stainless steel. Die-cast zinc housings are non-corrosive, lightweight, and are available with either a bronze bearing or ball bearing insert. Pressed steel housings, plated with a rust proof finish, are available with either a bronze bearing or ball bearing insert. Stainless steel housings are USDA/FDA approved, have UHMW-PE bearing inserts and are ideal for wash-down applications in wet or harsh environments. Solid UHMW-PE Bearings are made completely from UHMW-PE are USDA/FDA approved and are self-lubricating.
Heavy gauge pressed steel two-piece housing is crimped together at the bolt holes & has a rust-proof plated finish
Bearing inserts are encased in an extra thick, non-conductive oil resistant rubber liner which corrects up to a 2° misalignment while reducing vibration & noise
Ball bearing is pre-lubricated & made to ABEC-1 tolerances
Wide inner race locks securely to the shaft with two set screws
Neoprene seal keeps contaminants out allowing for usage in wet or dry conditions
